Aerko International
3410 NE 5th Avenue, Oakland Park, Florida 33334
MATERIAL SAFETY DATA SHEET
DATE OF PREPARATION: January 29, 1990 EMERGENCY TELEPHONE NUMBER:(954) 565-8475
LAST UPDATED: January 3, 2005 AFTER HOURS: 800-424-9300
SECTION I: PRODUCT IDENTIFICATION
Product Name: CLEAR OUT, KEYHOLER, AUTO EJECTOR COMMAND PAK II
Product Number: COA825, KH848, AEA841
Product Class: Aerosol Device (Total Release) Irritant
D.O.T. Shipping Class: ORM-D Consumer Commodity
SECTION II: HAZARDOUS INGREDIENTS
OCCUPATIONAL INGREDIENT EXPOSURE LIMITS VAPOR PRESSURE
TLV PEL
PROPRIETARY BLEND CARRIER 1000 PPM 223 PPM 96.55 PPM
TRADE SECRET: As defined in Hazard Communication
Act 29 CFR 1910.1200 Para 1 (i) end Appendix D to
CFR 1910.1200
PROPELLANT: Dymel 134A 1000 PPM 1000 PPM 96 PSIG @ 70o F
PERCENT
ACTIVE INGREDIENT
ORTHOCHLOROBENZALMALONONITRILE 0.05 0.05 N/A
OLEORESIN CAPSICUM 2 MILLION SHU None Established Not Known
SECTION III: PHYSICAL DATA
Boiling Range: 237
Vapor Density: 2.1 (air=1) Heavier than air
Percentage Volatile by weight: 98%
Evaporation Rate: 1.7 (Butyl Acetate=1)
Weight per gallon: Greater than 9 lbs.
Specific Gravity: 0.786 @ 68o F
Appearance: Transparent Cloud
Odor: Slight Pungent Odor
SECTION IV: FIRE AND SAFETY EXPLOSION HAZARD DATA
Flammability Classification OSHA: Non Flammable
Shipping Classification D.O.T.: ORM-D
Flash Point: 165.5o F
Flammable Levels in Air: Lower: N/A Upper: N/A
Extinguishing Media: Foam, Water Fog, CO2
Unusual Fire and Explosion Hazards: Do not expose to heat or flame or store above 120o F as high internal pressures may cause leaking.
Special Fire Fighting Procedures: Full protective equipment including self contained breathing apparatus should be used, Fog nozzles should be used to cool closed containers to prevent pressure buildup. Move undamaged containers from fire area if accomplished without risk.
SECTION V: HEALTH HAZARD DATA
PRIMARY ROUTE (S) OF ENTRY: Dermal, Inhalation
EMERGENCY AND FIRST AID PROCEDURES
EYES: Flush eyes with large quantities of water to speed recovery. Face subject into wind or forced air source such as fans or air conditioning outlet.
SKIN CONTACT: Wash affected area with soap and water to avoid transfer to more sensitive areas. Slight burning sensation with skin contact in most areas. Use no creams or salves.
INHALATION: Irritant, stimulation of facial nerves causes feeling of restricted airway. No danger exists for asphyxiation. Remove persons to fresh air.
INGESTION: Severe burning heartburn sensation may cause nausea. Seek medical attention if nausea persists.
PHYSIOLOGICAL EFFECTS AND HEALTH INFORMATION
EYE EFFECTS: This product is an eye irritant, Tearing and redness may occur. This product has been thoroughly tested by FDA approved Labs and has been found to have minor non persistent eye irritation, to be non toxic, and not to cause dermatitis.
SECTION VI: REACTIVITY DATA
STABILITY: Stable
HAZARDOUS POLYMERIZATION: Will Not Occur
INCOMPATIBILITY (MATERIALS TO AVOID): Strong Acids, Alkalies and Oxidizers.
SECTION VII: SPILL OR LEAK PROCEDURES
STEPS TO BE TAKEN IN CASE MATERIAL IS RELEASED OR SPILLED: Ventilate area. Remove all possible sources of ignition. Avoid prolonged breathing of vapors. Confine spill with inert absorbent. Wear protective equipment during clean up.
WASTE DISPOSAL: Incinerate in an approved incinerator or dispose of in accordance with Local, State and Federal Regulations.
RESPIRATORY PROTECTION: Use NIOSH/MSHA approved Chemical/Mechanical type filter system to remove a combination or particles, gas & vapor. Use air line if necessary.
VENTILATION: Use adequate ventilation in volume and pattern to keep LEL and TLV's in Section II below recommended level to produce explosion or fire. General mechanical ventilation should comply with OSHA 1910.94.
PROTECTIVE GLOVES: Use rubber gloves.
EYE PROTECTION: Safety glasses or goggles with splash guards or side shields.
OTHER PROTECTIVE EQUIPMENT: Prevent prolonged skin contact to contaminated clothing.
SECTION IX: SPECIAL PRECAUTIONS
PRECAUTIONS TO BE TAKEN IN HANDLING AND STORING: Store in a cool dry area away from sources of ignition. When storing large quantities, store in building designed and protected against fire.
DO NOT STORE IN DIRECT SUNLIGHT OR ABOVE 120O F.
OTHER PRECAUTIONS: "FOR INDUSTRIAL USE ONLY" Do not take internally. If ingested, DO NOT INDUCE VOMITING. Consult a physician.
SECTION X: Hazardous Material Identification System
HEALTH
0-No Significant Health Risk
1-Irritation or Minor Reversible Injury Possible
2-Temporary or Minor Injury May Occur
3-Major Injury Likely Unless Prompt Action is Taken and Medical Treatment is Given
4-Life Threatening; Major Permanent Damage May Result from Single or Repeated Exposures
FLAMMABILITY
0-Materials Will Not Burn
1-Flash Point Above 200O F
2-Flash Point Above 100O F below 200O F
3-Flash Point Between 73O F and 100O F
4-Flash Point Below 73O F
PHYSICAL HAZARD
0-Material that are normally stable even under fire conditions and will not react with water.
1-Material that are normally stable but can become unstable (self-react) at high temperatures and pressures; may react non violently with water to undergo hazardous polymerization in the absence of inhibitions.
2-Materials that are unstable; may react violently with water and undergo violent chemical changes with low risk for explosion.
3-Materials that may for explosive mixtures with water or undergo other chemical change at normal temperatures.
4-Materials capable of explosive water reaction, decomposition or polymerization.
CLEAR OUT H.M.I.S.
Health: 1
Flammability: 0
Physical Hazard: 0
THE INFORMATION CONTAINED HEREIN IS BASED ON TECHNICAL DATA WHICH WE BELIEVE TO BE RELIABLE, HOWEVER, SINCE THE CONDITIONS UNDER WHICH THIS INFORMATION MAY BE APPLIED ARE BEYOND OUR CONTROL WE CAN ASSUME NO LIABILITY FOR RESULTS OF ITS APPLICATION. THIS INFORMATION SHOULD BE USED ONLY BY PERSONS HAVING SUFFICIENT TECHNICAL SKILL TO MAKE INFORMED JUDGMENTS REGARDING ITS APPLICATION.
Aerko International
3410 NE 5th Avenue
Oakland Park, FL 33334